Installing The Diagonal And Eyepiece; Installing The Finderscope - Celestron TRAVEL SCOPE 80 Manuel D'instructions

INSTALLING THE DIAGONAL AND EYEPIECE

The Travel Scope uses a 45 degree erect image diagonal that corrects the image to be right side up and oriented
correctly left-to-right which is much easier to use for terrestrial observing . The diagonal can be rotated to any position .
To install the diagonal and eyepiece:
1 Loosen the two thumbscrews on the rear on the telescope
optical tube and remove the cap covering the focuser .
2 Remove the caps from both ends of the diagonal and insert
the chrome barrel of the diagonal inside the focuser of the
telescope optical tube . Secure the two thumbscrews to hold it
in place .
3 Loosen the set screws on the side of the diagonal and insert
the chrome barrel of the eyepiece into the diagonal . Secure the
thumbscrews to hold the eyepiece in place .

INSTALLING THE FINDERSCOPE

The Travel Scope comes with a small optical finderscope to help
you aim the main scope at a distant target .
To install the finderscope:
1 Locate and remove the two silver thumb nuts on the left side of
the telescope tube .
2 Place the finder bracket over the two exposed threaded shafts .
3 Replace the nuts to hold the finderscope in place .
8 I ENGLISH
Objective Lens
Finderscope
Finderscope
Bracket
Knurled Adjustment
Nuts Screws
Eyepiece