Télécharger Imprimer la page

Siren R3 Manuel De L'utilisateur page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
1 bleep:
Speed Sensing Low Sensitivity. For extreme
conditions, high winds and flowing water.
Tone:
Hold down Power button and short press the X button to
scroll through the five tone options.
Nash Bobbin Glow Function:
Press and hold X and Power
buttons together for 2 seconds to enable/disable the pulsating
Bobbin Glow function. When the Bobbin Glow function is turned
on you will hear two bleeps of increasing pitch. When the
Bobbin Glow function is turned off you will hear two bleeps of
decreasing pitch.
Note:
This function is only available when used with Nash
Bobbin Glow Pipes T5019 and T5020 (not included).
Nash Bobbin Glow Pipes
Nash Bobbin Glow Pipes use fibre optic technology to replicate
the unique regenerating glow of the Siren R3 LED in your Nash
Bobbin head. Glow Pipes screw into the direct connection
thread in the front of the R3's body, a Nash Bobbin Head screws
on to the end with the soft rubber diffuser.
Low battery warning:
The R3 Head emits five consecutive 1
second beeps when switched on to warn you battery power
is low. Replace immediately to retain full functionality. Note
that the first warning of reduced battery power will be dimmer
LEDs.
R3 RECEIVER:
Insert Battery:
Open battery compartment using crosshead
screwdriver and insert 1 x CR123A 3V battery (not supplied).
To Turn R3 Receiver On/Off:
Press and hold Power button for
2 seconds.
When turned on LEDs light sequentially from left to right with a
sequence of increasing pitch bleeps and the handset vibrates.
P3
SIREN R3 USER MANUAL
2020 SIREN R3 USER MANUAL 25.02.20.indd 3
13/07/2020 08:41

Publicité

loading