Transporting Bender; Maintenance - Textron GREENLEE 555 Serie Manuel D'instructions

Transporting Bender

Refer to the "Identification" section of this manual.
• The handle (1) is adjustable for height. To adjust,
remove the two snap pins and raise or lower the
handle to one of its positions. Reinstall the snap pins.
• To lift the entire bender, place a sling around the lifting
bar (2). DO NOT USE THE HANDLE.
Greenlee / A Textron Company
555 Series Electric Benders
®

Maintenance

Zeroing 555DX
1. Use BEND or UNLOAD on the pendant to align the
shoe groove with zero on the bender decal.
2. Press and hold the
Replacing the Fuse
For continued protection against risk of fire and
electric shock, replace ONLY with same manufacturer,
type, and rating of fuse.
Failure to observe this warning could result in severe
injury or death.
If the fuse needs to be replaced, use only a Cooper
Bussmann GBB-30 Very Fast-Acting fuse, 1/4" x 1-1/4"
(6.3 x 32 mm).
24
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
button while pressing JOG.