Kuppersbusch FWKU1870.0X Mode D'emploi page 22

It is recommended that you installed your appliance in a place where the ambient temperature is between 16-32°C. If
the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected
and it may not be possible to obtain temperature between 5-20°C/5-20°C.
Temperature setting
A ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
B Decrease temperature of 1 degree Celsius or Fahrenheit.
C Raise temperature of 1 degree Celsius or Fahrenheit.
Display shows upper zone temperature at its setting. 5 seconds later, it will automatically
D
turn to actual temperature inside the wine cellar till reaching setting one.
E Temperature display in Celsius.
F Temperature display in Fahrenheit.
Display shows lower zone temperature at its setting. 5 seconds later it will automatically
G
turn to actual temperature inside the wine cellar till reaching setting one.
Setting temperature checking switch. Touch key H once, display switch to setting
H
temperature with one zone flashing and the other one no flashing. touch it again to switch
the flashing. Only flashing zone could be adjusted by raise or decrease key. 5 seconds
later without operation display automatically turn to inner cabinet actual temperature till it
reaches the setting one.
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
J Light ON/OFF switch, turn on and turn off the light.
Temperature selection
NOTE: both two zones temperature could be set at 5~20ºC/5~20ºC, But actually lower zone will
be always minimally 4ºC higher than upper zone. Maximum temperature difference between
both compartments is 10°C. Always set cooler temperature in the upper compartment and
warmer temperature in the lower compartment (example: 5°C upper and 15°C lower).
 When the unit is plugged in for the first time, the LED readouts will show the inner cabinet's
actualtemperature and working toward last setting .touch key H to check setting temperature and set
desiretemperature by Kye B and C.
 Increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will decrease by 1°C
or1ºF if you touch the "-" (B) mark once. Only flashing zone could be adjusted