Kuppersbusch FWKU1870.0X Mode D'emploi page 20

Reversible door for
1. Remove the ventilation grille (1) by unscrewing the screws (3) & (4). (Fig. 1)
2. Remove the bottom hinge (5) by unscrewing the four lock screws (6). Be careful to hold the glass door firmly after removing
the screws. (Fig. 2)
3. Gently pull down to remove the glass door from the right top hinge and place it on a padded surface to avoid the risk of damage.
Then remove the right top hinge. (Fig.3)
4. Unscrew and transfer the hinge pin (7) and/or the door stopper of the bottom hinge to the opposite side. (Fig. 4)
5. Pop out the cover caps on the left side of the cabinet and use them to cover the screw holes on the right hand side.
6. Screw the alternative left top hinge (8), included in the fittings, on the left hand side of the cabinet. (Fig. 5)
7. Rotate the door at 180° and relocate the door to the designated position. Then screw the bottom hinge assembly on the
left designated position (Fig.6) and tighten it after the door is leveled.
8. Reassembly the ventilation grille.
FWKU1870.0X