Water Drainage Method - Global Industrial 293065 Manuel De L'utilisateur

TIPS FOR CORRECT USE
To get the optimal performance from your appliance, follow
these recommendations:
• Close the windows and doors in the room to be air
conditioned (Fig. 24). When installing the appliance semi-
permanently, you should leave a door slightly open (as little
as 1 cm) to guarantee correct ventilation.
• Protect the room from direct exposure to the sun by partially
closing curtains and/or blinds to make the appliance more
economical (Fig. 25).
• Never rest objects of any kind on the appliance.
• Do not obstruct the air intake and outlet (Fig. 26). Leave
the grilles free.
• Make sure there are no heat sources in the room.
• Never use the appliance in very damp rooms (laundry
room, for example).
• Never use the appliance outdoors.
• Make sure the appliance is standing on a level surface.
Fig. 24
Close
doors and
windows
Fig. 26
Do not
cover the
appliance

WATER DRAINAGE METHOD

When there is excess water condensation inside the unit,
the appliance stops running and shows
as mentioned in SELF-DIAGNOSIS). This indicates that
the water condensation needs to be drained using the
following procedures:
Manual Draining (Fig.27)
Water may need to be drained if running in dehumidify mode
or if the unit is operating in Cool mode and running under
very hot/humid conditions for a prolonged period of time.
1. Unplug the unit from power source.
2. Place a drain pan under the lower drain plug. See diagram.
3. Remove the lower drain cap.
4. Water will drain out and collect in the drain pan (not supplied).
5. After the water is drained, replace the lower drain plug firmly.
6. Turn on the unit.
Portable Air Conditioner
Fig. 25
Close
curtains
(FULL TANK
Continuous Draining (Fig.28)
While using the unit in dehumidifier mode, continuous
drainage is recommended.
1. Unplug the unit from the power source.
2. Remove the drain plug. Water may drip/spill after
the plug is removed. Have a pan ready to collect any
residual water.
3. Unscrew the drain cap of continuous drain outlet.
4. Connect one end of the garden hose (sold separately) or
drainage hose (not supplied) to the drain outlet then lead the
other end into a drain or bucket that is lower than the unit.
5. Turn on the unit.
Middle Drainage
When running the unit in Dry mode, you can choose the
way to drain:
1. Unplug the unit from the power source.
2. Remove the drain cap (Fig.27). While doing this operation
some residual water may spill so please have a pan to
collect the water.
3. Connect the drain hose (1/2" or 12.7mm, not supplied)
(Fig.28).
4. The water can be continuously drained through the hose
into a floor drain or bucket.
5. Turn on the unit.
Fig. 27
Fig.28
Note:
• Condensate may flow out after removing the drain cap, if
the unit is running in Cool and Dry mode. When you want to
remove the garden hose, prepare a drip tray (not supplied)
to collect the condensate from the drain outlet.
• Please be sure that the height of the drain and section
of the drain hose should not be higher than that of the
drain outlet, or the continuous drainage may not work
properly (See Fig. 19 & Fig. 20 on page 7).
• During Cool mode, it is recommended to disable
continuous drainage by replacing the drain cap to the
drain outlet, to reach the maximum performance.
9
User's Manual
Drain cap
Garden or
drainage hose