ResMed MIRAGE Mode D'emploi page 5

3 Detach the headgear from the mask frame by
squeezing and releasing both headgear clips.
Note: The headgear does not normally need to
be disassembled. If disassembled, see section
on "Reassembling the Headgear".
4 Remove the ports cap from the mask
frame (Fig. C-3).
5 Firmly pull the mask cushion away from the
mask frame (Fig. C-4).
C
LEANING THE
Note: The mask system (excluding the
headgear, swivel and short tube) is validated
for multipatient use. Clinicians should refer to
the M V Disinfection / Sterilization Guide
IRAGE ISTA
for details.
W
EEKLY
Hand wash the headgear in warm, soapy
water. Use pure soap. Rinse well and allow it
to air dry out of direct sunlight.
Note: The headgear may be washed without
being disassembled.
D /A
AILY FTER EACH
Hand wash the mask components in
lukewarm, soapy water. Use pure soap. Rinse
the components well and allow them to air
dry out of direct sunlight.
PRECAUTIONS
• Do not use solutions containing bleach,
chlorine, alcohol, aromatics, moisturizers
antibacterial agents, or scented oils to
clean any part of the mask system or air
tubing. These solutions may cause damage
and reduce the life of the product.
• Do not expose any part of the mask
system or tubing to direct sunlight as it
may deteriorate.
M
ASK
U
SE
R
EASSEMBLING THE
Figure D
When disassembled, the headgear has four
parts:
A: Left strap; B: Middle strap; C: Cross-over
buckle; D: Right strap
1 Lay out the four parts of the headgear as
shown in Figure D-1.
2 Following Figure D-2 thread the straps BR
and BL through the cross-over buckle
(part C).
3 Thread strap BR through the buckle on
Part A. Thread strap BL through the buckle
on Part D (Fig. D-3).
4 Thread the straps of part A and part D
through the buckles on part B (Fig. D-4).
5 With the headgear clip facing down, fit the
headgear clip onto the hole on the
headgear. While pressing the headgear tab
down, rotate the headgear clip away from
the tab to lock it into place (Fig. D-5).
Repeat this with the other headgear clip.
R
EASSEMBLING THE
Figure E
1 Insert the mask cushion into the groove of
the mask frame (Fig. E-1). Fit the top
section first and then work your way
around, pushing the mask cushion into the
mask frame.
Note: The diamond markers on the mask frame
and on the mask cushion (one on top,
two at the bottom) must line up.
2 Push the ports cap onto the mask ports
(Fig. E-2).
3 Attach the vent cover to the mask elbow.
To do this, insert the elbow into the
retaining ring of the vent cover. Push the
vent over the front of the mask elbow
(Fig. E-3). Ensure that the lip of the vent
cover is securely seated in the groove of
the elbow.
4 Connect the short air tubing to the mask
elbow.
5 Connect the swivel to main air tubing ready
for next use (Fig. E-4).
H
EADGEAR
M
ASK