Resolving Failures Yourself - Inventum NH010 Mode D'emploi

REPLACING LED LIGHTING
This appliance has been provided with LED lighting. This lighting lasts for a longer period of time. When a LED lamp
in the appliance is broken, you are not able to replace it yourself. Contact the Inventum service department.
7

resolving failures yourself

Breakdown
Appliance does not do anything
Temperature in the refrigerator is
not cold enough
Temperature in the refrigerator is
too cold
The surfaces on the inside
are wet
The exterior of the appliance
is wet.
The refrigerator smells / has a
nasty odour
The doors do not close properly
Note: bubbling and expansion noises in the cooling circuit are normal.
28
• English
Solution
Check that the plug is properly inserted in the socket.
Check if there has been a power failure in the house.
Check the plug.
Check the fuse in the group box.
Check that the voltage in the house system corresponds with the voltage required
for the appliance.
Check the socket. Insert the plug in a different socket of which you are certain
that it works.
Check that the refrigerator is not overfilled.
Check that the interior temperature corresponds with the set temperature.
Is the appliance located in direct sunlight or near a heat source?
Check that the ambient temperature corresponds with the climate class
of the appliance.
Are the doors of the appliance opened regularly? As a result of the air humidity
in the surrounding area, a lot of humidity may accumulate in the appliance when
the doors are opened frequently.
Increase the temperature of the appliance.
The lowest temperature should only be used for quick freeze and should preferably
be set 2 hours before food is placed in the appliance. If not, it is possible that
the temperature of the appliance gets below 0°C, because the compressor
is continuously active.
This is caused by condensation - dry the interior of the appliance.
This is caused by condensation - dry the exterior of the appliance.
Check if it contains food that has passed its use by date or if it contains any opened
packagings.
Check whether anything has leaked on the shelves, in the compartments and in
the drawers of the refrigerator. If necessary, remove drawers to be able to check
everything properly. If something has leaked and has not been cleaned, this could
eventually lead to nasty smells.
Check that the defrost water drain is not blocked and/or the receptacle for defrost
water at the rear is not full.
Check that there is nothing between the doors that prevents them from closing.
Check that the door compartments and shelves are placed properly.
Check that the door rubbers are properly placed and are not turned or torn.
Check that the appliance is level.