Resolving Failures Yourself - Inventum YK010 Mode D'emploi

7

resolving failures yourself

Breakdown
The appliance
no longer works
The interior lighting
does not work.
Temperature in the larder
is too high or too low
The appliance is working
continuously.
There is water
in the lower section
of the larder.
Unusual or loud noises
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the larder.
Noises that can be easily remedied:
• Noise due to the fact that the appliance is not level – position the appliance using the front adjustable feet. If necessary,
place soft material under the rear wheels, particular in case of a tiled floor.
• Friction against other furniture – move the appliance.
• Grinding of drawers or shelves – remove the shelf or drawer and then place it back.
• Noise of colliding bottles – place the bottles apart.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compressor
(activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences
and flow of cooling liquid).
Cause
There is an interruption
in the power supply.
The lamp is defective or the plug
is not in the socket.
Wrong setting of the thermostat.
The ambient temperature is
higher or lower than the
temperature indicated in the
table with technical data.
The appliance is located in direct
sunlight or near a heat source.
The ventilation at the rear of the
appliance is hindered.
The door of the larder is opened
too frequently or remains open
for too long.
The door is not closed properly.
The compressor does not work
often enough.
The door rubber is loose.
Wrong setting of the thermostat.
The opening of the defrost water
drain is clogged.
The ventilation within the cooler
section is hindered.
The appliance is not level
and stable.
The appliance is standing against
something.
Solution
- check that the plug is properly inserted in the socket
- check that the power cable is not damaged
- check that there is voltage on the socket by connecting
a different appliance, such as a night lamp
- check that the appliance is on by setting the thermostat
higher than 0
Check the solutions above or have the lamp replaced.
- turn the thermostat to a different position
The appliance is intended for operation in an
ambient temperature indicated in the table with technical
data supplied with the appliance.
Change the location of the appliance according
to the information in the instruction manual.
Keep the appliance 10 cm away from the walls,
for sufficient ventilation.
Open the door less often and/or reduce the time that
the door remains open.
Make sure the foods are placed in such a way that they
do not hinder the door when it is being closed.
Check that the ambient temperature is not lower than
the range of the climate class.
Fasten the door rubber or have it replaced.
- turn the thermostat to a higher position
Clean the opening of the defrost water drain by means
of the skewer.
Check that the food does not make contact with the rear
wall of the refrigerator.
Level the appliance with the adjustable feet.
Place the appliance in such a way that it is not standing
against anything.
25
English •