Error Messages; Resolving Failures Yourself - Inventum CD010 Mode D'emploi

8

error messages

Each time the door of the cooler or freezer section is opened, a noise sounds to indicate that the appliance is working.
If the door is open for too long (more than 2 seconds), an alarm is activated to indicate that the door should be locked to
maintain the temperature in the refrigerator.
In case of a power failure, all settings are saved. Once the refrigerator receives power again, it will function with the
previously selected settings.
The following error messages may occur on the display. In such a case, contact customer service.
Error Description
message
E1
Problem with the temperature in the cooler
section
E2
Problem with the temperature in the
freezer section
E4 Breakdown of the automatic cooler sensor
E5 Breakdown of the automatic defrost
sensor
9

resolving failures yourself

Breakdown
Appliance does not do anything
Temperature in the refrigerator
is not cold enough
Temperature in the refrigerator
is too cold
The surfaces on the inside
are wet
The exterior of the appliance
is wet.
28
• English
Solution
Check that the plug is properly inserted in the socket.
Check if there has been a power failure in the house.
Check the plug.
Check the fuse in the group box.
Check that the voltage in the house system corresponds with the voltage required
for the appliance.
Check the socket. Insert the plug in a different socket of which you are certain
that it works.
Check that the refrigerator is not overfilled.
Check that the interior temperature corresponds with the set temperature.
Is the appliance located in direct sunlight or near a heat source?
Check that the ambient temperature corresponds with the climate class
of the appliance.
Are the doors of the appliance opened regularly? As a result of the air humidity in the
surrounding area, a lot of humidity may accumulate in the appliance when the doors
are opened frequently.
Increase the temperature of the appliance.
The lowest temperature should only be used for quick freeze and should preferably
be set 2 hours before food is placed in the appliance. If not, it is possible that
the temperature of the appliance gets below 0°C, because the compressor is
continuously active.
This is caused by condensation - dry the interior of the appliance.
This is caused by condensation - dry the exterior of the appliance.
Error Description
message
E6
Communication failure
E7
Breakdown in the ambient temperature
sensor
EH Breakdown in the humidity sensor