Cleaning The Surface Of The Filter; Replacing The Filter - Philips AC4236 Mode D'emploi

Cleaning the surface of the filter

Filter alert light status
The filter cleaning alert
displays on the screen
(fig ) �
v
1
Switch off the air purifier and unplug from the power socket�
2
Pull the back cover and remove it from the appliance (fig
3
Pull the filter from the appliance (fig
4
Clean the surface of the filter with a vacuum cleaner (fig
5
Put the filter back into the appliance (fig
6
Reattach the back cover (fig
7
Put the plug of the air purifier in the power socket�
8
Touch the button to switch on the appliance�
9
Touch and hold the filter status check/reset button
cleaning time (fig
y
» The screen displays a message "Filter cleaning completed"�
10
Wash your hands thoroughly after cleaning the filter�

Replacing the filter

Understanding the healthy protection lock
This air purifier is equipped with a filter replacement indicator to make sure that the air
purification filter is in optimal condition when the air purifier is operating� When the filter
need to be replaced, the filter replacement alert
If the filter is not replaced in time, the air purifier will stop operating and automatically lock to
protect the air quality in the room� Replace the filter as soon as possible�
Replacing the filter
Note:
• The filter is not washable or reusable�
• Always turn off the air purifier and unplug from the electrical outlet before replacing the
filter�
EN
12
Action
Clean the surface of the filter with a vacuum cleaner�
)�
w
)�
f
)�
g
)�
)�
c
)�
x
for 3 seconds to reset the filter
lights up red�