Introduction; Preparation - NAUTIKA THEIA 90 CFM Manuel D'installation

INSTALLATION GUIDE
BATHROOM FAN WITH LIGHTS
THEIA 90 CFM WITH 2 LIGHTS MODEL
Table of contents
Introduction .................................................................................... 1
General safety information and warnings ........................................ 2
List of parts and accessories supplied ............................................. 2
Dimensions, dimension requirements, specifications ...................... 3
Wiring diagram ............................................................................... 4

INTRODUCTION

You must read and save these instructions
Please read these instructions carefully before installing, operating or servicing the fan. Failure to comply with the instructions contained herein
could result in personal in jury or property damage. We recommend that you keep this booklet for future reference.
This Theia Series bathroom fan uses state-of-the-art technology and is designed with a built-in thermal cut-off for safety and to prolong the life
of the motor.

PREPARATION

• Tools Required for Assembly (not included):
Hammer, Drill Bits, Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,
Phillips Screwdriver, Utility Knife
• Helpful Tools (not included): Electric Drill, Wood Screws
• Carefully remove unit from carton.
• Check area above installation location to be sure that wiring can run
to the planned location and that duct work can be run and the area is
sufficient for proper ventilation.
BATHROOM FAN - THEIA 90 CFM WITH 2 LIGHTS
Installation steps (new construction) .......................................... 4 - 5
Installation steps (existing construction) ..................................... 6 - 7
Maintenance ................................................................................... 8
Troubleshooting guide ..................................................................... 9
Limited warranty ............................................................................. 9
• Inspect duct work and wiring before proceeding with installation.
• Before installation, provide inspection and future maintenance
access at a location that will not interfere with installation work.
• You may need the help of a second person to install this fan; one
person on the attic side and one on the room side.
• Note: Installations may vary depending on how the previous bath fan
was installed. Supplies necessary for the installation of your bath fan
are not all included; however, most are available at your local home
improvement or hardware store.
1