Belkin F1D080 Mode D'emploi page 2

P73037/F1D080 univ/man.qxd
1) There is no image on the monitor, or the images are distorted.
• Make sure the monitor is turned on.
• Make sure the correct port is selected on the OmniView
• Check all monitor cables. Make sure they are properly attached.
• Your monitor cannot handle the current resolution or refresh rates. Change
the DIP switch settings to Setting A shown in Table 3 and restart the
Macintosh
®
2) There is no response from the keyboard and/or mouse.
• Make sure that the Adapter is properly connected to the Macintosh
computer, and to the correct ports on the OmniView
• Make sure the correct port is selected on the OmniView
• Make sure that the OmniView
• Check all the cables. Make sure they are properly attached, and that they
are straight-through.
3) The keyboard keys are not mapping correctly.
• Make sure that SW7 is set correctly. It must be ON for a 101-key, and OFF
for a 104-key.
4) The mouse is not working or the motion is erratic.
• The mouse must be PS/2 compatible. A serial mouse on the OmniView
will not work with the Adapter.
For more information, consult the documentation included in your OmniView
4/21/00 2:01 PM
Troubleshooting
computer.
™ has a power adapter and is turned on.
7
Page 7
™ .
®
™ .
™ .
En
™
™ .