Publicité
Les langues disponibles
Les langues disponibles
make the tool unusable or unsafe. If the tool has been dropped or thrown,
examine the tool closely for bent, cracked or broken parts and air leaks.
STOP and repair before using or serious injury could occur.
j.
Do not exceed any pressure rating of any component in the system.
Maximum operating pressure of 90 PSI is measured at the tool inlet
while the tool is running. The pressure drop between the compressor
and tool needs to be compensated for at the compressor.
k.
Do not depress trigger when connecting the air supply hose.
l.
Never trigger the tool when not applied to a work object. Attachments
must be securely attached. Loose attachments can cause serious injury.
any damaged or worn hoses or fittings. Tool performance or durability may
be reduced.
Service
Tool service must be performed only by qualified repair personnel.
a.
b.
When servicing a tool, use only identical replacement parts. Use only
authorized parts.
c.
Use only the lubricants supplied with the tool or specified by the
manufacturer.
Hausfeld. Do not use the tool if any shields or guards are removed or
altered. Do not use the tool as a hammer. Personal injury or tool damage
may occur.
Air Source
a.
Never connect to an air source that is capable of exceeding 200 PSI. Over
pressurizing the tool is able to result in bursting, abnormal operation,
breakage of the tool or serious injury to persons. Use only clean, dry,
regulated compressed air at the rated pressure or within the rated
pressure range as marked on the tool. Always verify prior to using the
tool that the air source has been adjusted to the rated air pressure or
within the rated air-pressure range.
b.
Never use oxygen, carbon dioxide, combustible gases or any bottled
gas as an air source for the tool. Such gases are capable of explosion and
serious injury to persons.
O
a power source. Use filtered, lubricated, regulated compressed air only. Use
CO
2
of a reactive gas instead of compressed air may cause the tool to explode
which will cause death or serious personal injury.
Do not drop or throw the tool. Dropping or
throwing the tool can result in damage that will
Do not exceed the maximum operating pressure of
the air tool (90 PSI). This can reduce the life of the
tool.
This air tool requires lubrication before the initial
use and before and after each additional use.
Clean and check all air supply hoses and fittings
before connecting the tool to an air supply. Replace
Do not make any modifications to the tool without
first obtaining written approval from Campbell
Do not use any type of reactive gases, including,
but not limited to, oxygen and combustible gases, as
9
Publicité
