TensCare OVA+ Mode D'emploi page 20

Make sure the Ova+ is switched off before applying or removing the
•
pads.
Ensure that the skin is clean and thoroughly dry before attaching the
•
pads, as they will not adhere well if the skin is wet or greasy.
Do not worry if a small part of each pad covers the pubic hair. After
•
use the pads can be removed gently without pulling out the hair.
If a large part of the pad area is covered with hair the stimulation may
•
be less effective. If hair needs to be removed, wait 48 hours after
shaving, waxing or using depilatory cream before applying the pads,
to avoid irritating the skin.
Remove the pads from the skin or from the liner by peeling them back
•
from the edge of the pad. Do not remove by pulling on the pad's
"pigtail" wire.
• If you find that a small part of the pad overlaps the top of your thigh,
and that this is uncomfortable, then it is possible to cut off this part
using scissors. Before cutting make sure that you are cutting from the
opposite end to the lead wire and that you are not cutting through any
of the wires which run through the pad. Do not cut off more than a
small triangular piece, with sides no more than 20mm long and an
area no greater than 200 sq.mm.
See diagram:
Ensure that the lead wire is slack at all times when the Ova+ is in use.
Excessive force applied to the lead wire could cause a "pigtail" to separate
from its pad.
Care of Electrode Pads
The electrode pads supplied with your Ova+ unit are self-adhesive and
can be used several times. Skin must be allowed to breathe, so the pads
should be removed periodically.
20