Table Des Matières; Description; Safety; Purpose Of This Manual - Greenlee 746A Manuel D'utilisation

Table of Contents
Description .................................................................... 2
Safety ............................................................................ 2
Purpose of this Manual ................................................. 2
Important Safety Information .....................................3-5
Identification and Illustration ......................................... 6
Specifications ................................................................ 7
Setup and Operation .................................................. 8-9
Capacity ...................................................................... 10
Maintenance ................................................................ 11
Troubleshooting ........................................................... 12

Description

Greenlee Hydraulic Knockout Drivers are self-contained
knockout drivers intended to be used with Greenlee
punches, dies, and drawstuds for punching holes
through mild steel, stainless steel, brass, copper,
aluminum, fiberglass, and plastics.
These tools are designed to be used with the following
Greenlee accessories:
• Standard punches, dies, and drawstuds
• Slug-Buster punches, dies, and drawstuds
®
• Slug-Splitter punches, dies, and drawstuds
®
• SPEED PUNCH Knockout System
®
• Electronic connector panel punches
• Special shape punches, dies, and drawstuds ("D",
Double "D", Key, Square, Rectangular, and Oiltight
with notches)
Standard, Slug-Buster, Electronic Connector Panel
Punches, and special shape punches can punch holes
through mild steel, brass, copper, aluminum, fiberglass,
and plastics, with limited stainless steel capability.
Slug-Splitter punches, dies, and drawstuds are capable
of punching through all of these materials and are
optimized for stainless steel. Refer to the "Capacity"
section in this manual for detailed information on
maximum driver rating.
Do not exceed the rated capacity of the punch or driver.
Greenlee Tools, Inc.

Safety

Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information
for avoiding hazards and unsafe practices related to
the use of this tool. Observe all of the safety
information provided.

Purpose of this Manual

This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tools:
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge at www.greenlee.com.
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
All specifications are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Kwik-Stepper, Slug-Buster, Slug-Splitter, and SPEED PUNCH are
registered trademarks of Greenlee Tools, Inc.
KEEP THIS MANUAL
2
Hydraulic Knockout Drivers
746A Hydraulic Ram
767 Hand Pump
1725 Foot Pump
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070