Installation; Appropriate Installation Location - Beko RCHE300K30WN Manuel D'utilisation

3

Installation

3.1. Appropriate
Installation Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
WARNING: Manufacturer shall
not be held l able for damages
B
that may ar se from procedures
carr ed out by unauthor zed
persons.
WARNING: Product must
not be plugged n dur ng
B
nstallat on. Otherw se, there
s the r sk of death or ser ous
njury!
WARNING:
If the door clearance of the
room where the product shall
be place s so t ght to prevent
pass ng of the product, remove
A
the door of the room and pass
the product through the door
by turn ng t to ts s de; f th s
does not work, contact the
author zed serv ce.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Please prov de at least 5cm d stance
for a r c rculat on between the back
s de of your product and the wall to
avo d condensat on on the rear panel
of product.
• Your product requ res adequate a r
c rculat on to funct on eff c ently.
If the product w ll be placed n an
alcove, remember to leave at least 5
cm clearance between the product
and the ce l ng, rear wall and the s de
walls.
3.2 Attaching the
plastic wedges
Use the plast c wedges n the prov ded
w th the product to prov de suff c ent
space for a r c rculat on between the
product and the wall.
1. To attach the wedges, remove the
screws on the product and use the
screws provided with the wedges.
2. Attach 2 plastic wedges on the
ventilation cover as shown in the figure.
10 / 23 EN
Refrigerator/User Manual