Klarstein AeroDry 10 Manuel page 30

EN
30
FAN Mode
Press the "MODE" key to select "FAN", and "FAN" indicator
light comes on. Only the fan will run in this mode and not
water is extracted.
HUMIDITY INDICATOR MODE
Start the appliance, the indicator light will turn on
automatically. The indicator light color will change according
to the humidity condition (RH = relative humidity):
• Red color means high humidity, RH > 80 %
• Green color means comfortable, 80 % ≥ RH ≥ 60 %
• Blue (Orange) color means dry, RH < 60 %
Press "Humidity Indicator light" key to turn on/off the light.
Note: It can take about 2 minutes after the humidity
before the indicator will change the colour e.g. if humidity
drops to 55 % may take 2 minutes before the indicator
changes to Blue (Orange).
HUMIDITY SETTING
Press the UP/DOWN keys to select the desired relative
humidity level, default relative humidity is 55 %.
If relative humidity 35 % is selected, the compressor will not
stop until the water tank is full.
TIMER (timer function)
Press timer to program time. "TIMER" light comes on while
timer is programmed. Before programming make sure that
the timer function has not been activated (the light must be
off). The following timer programs are available.:
a) Delayed power-on function (the appliance is in stand-by
status) USE key "UP" and "DOWN" to set the time period
(1~24 hours) The appliance will start once time reaches set
value.
b) Delayed power-off function (whilst the appliance is
running). The appliance will stop once time reaches set value.