Inakustik NF-A1 Mode D'emploi page 18

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NF-A1
Operation
Safety instructions
1. General information
Read, observe and obey the following safety instructions.
Please save the operating instructions.
Observe all the warning notices on the devices and in the operating instructions.
2. Proper use
Connect the product as indicated in the operating instructions.
Only use the cables and accessories provided by the manufacturer.
Use only appropriate stands, brackets, shelves and other devices for the
attachment and support of the products. When moving the support surfaces
upon which products are placed, be very careful in order to avoid injuries and
damage resulting from falling products.
3. Humidity
Keep the products in locations which do not have a high level of relative
humidity. Never use this device near water. Wetness can bypass the electrical
insulation and thus present a fatal danger, as it can for all devices not specially
designed to be water-resistant. The devices may not be exposed to dripping or
sprayed water. Objects which are filled with water, such as vases, may not
under any circumstances be placed on the
devices.
4. Product protection
Do not under any circumstances expose the devices to high levels of humidity.
Extreme temperature fluctuations, humidity and extended exposure to light can
damage the devices and alter their appearance.
Make sure that no foreign objects or liquids enter the device.
5. Positioning
Do not position the product near sources of heat, heaters, heating valves, ovens
or other heat-producing devices.
Never block the ventilation slots on the devices. The devices may only be stored
and operated in a temperature range from +5 to +40 °C.
The devices heat up during operation. To prevent unnecessary activation of the
overheat protection, air circulation must be granted to the devices.
Products without a magnetic shield may discolour or distort a nearby TV. A
distance of 0.5 m or greater is normally sufficient to prevent such disturbances.
Most TV's have a built-in corrector switch for such occurrences. When these
devices are switched off and switched on again a few minutes later, the images
should be largely corrected.
Do not place credit cards or other magnetic data carriers on the devices; the
information saved on them could be destroyed.
18

Publicité

Table des Matières
loading

Produits Connexes pour Inakustik NF-A1

Table des Matières