Cable Bend Radius; Setup - NDS ZEROWIRE G2 Mode D'emploi

ZEROWIRE® G2 Receiver Wiring
(1)
(1)
DVI input (DVI cable)
(2)
Power to transmitter (24 VDC)
(3)
Power to display (24 VDC)
4.5

Cable Bend Radius

CAUTION!
Degradation of the video signal
We recommend that the bend radius of metallic cables be no less than 2.5 inches (63 mm) or
7 times the diameter of the cable whichever is greater. Sharper bends may damage the
cable and/or degrade the video signal.
4.6

Setup

Linking the Transmitter and Receiver
Prior to placing the ZEROWIRE® G2 system in service, the Transmitter and Receiver pair must be linked.
Once a Transmitter and Receiver pair is linked, they remain linked until the Transmitter is explicitly linked to
another Receiver or the Receiver is explicitly linked to another Transmitter.
NOTE!
If a linked pair is turned off they will automatically link to each other when they are turned
on again.
(2)
(3)
Wiring Receiver
Set up and Installation
en
| 19