Risk Of Bursting - Hydrotech HDS Serie Mode D'emploi

READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF BURNS

RISK OF BURSTING

RISK FROM MOVING PARTS
Operator's Manual
IMPORTANT SAFETY INSTRUCTIONS
POTENTIAL CONSEQUENCE
Serious injury may occur from
touching the engine, muffler or heat
exchanger. These areas can remain
hot for some time after the pressure
washer is shutdown.
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments
or accessories are used.
Serious injury or death may occur if
attempting to start the pressure washer
when the pump is frozen.
Serious injury may occur to the
operator from moving parts on the
pressure washer.
PREVENTION
Never allow any part of your body to contact
the engine, muffler or heat exchanger.
Never make adjustments to the factory set
pressures.
Never exceed manufacturers maximum
allowable pressure rating of attachments.
Do not allow any hoses to make contact
with the engine, muffler, or heat exchanger
to prevent the possibility of bursting. Avoid
dragging the hoses over abrasive surfaces
such as cement.
Use only manufacturer recommended repair
parts for your pressure washer.
In freezing temperatures, the unit must always
be warm enough to ensure there is no ice
formation in the pump. Do not start the pressure
washer if it has been transported in an open
or non heated vehicle without first allowing the
entire unit to thaw.
Before making any adjustments, be certain the
engine is turned off. Be certain to disconnect
the battery ground terminal before servicing
and the ignition cable(s) is removed from the
spark plug(s). Turning the machinery over by
hand during adjustment or cleaning might start
the engine and machinery with it.
Do not operate the unit without all protective
covers in place.
7