Hydrotech HDS Serie Mode D'emploi page 6

READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF INJECTION
OR
SEVERE CUTTING INJURY
RISK OF
ELECTROCUTION
OR ELECTRICAL SHOCK
6
IMPORTANT SAFETY INSTRUCTIONS
POTENTIAL CONSEQUENCE
Serious injury or death could occur
from high pressure spray penetrating
the skin.
Serious injury or death may occur
from contact with electricity.
PREVENTION
Keep clear of nozzle and spray! Never put
your hand, fingers or body directly over the
spray nozzle.
Never point the high pressure discharge spray
at yourself or anyone else. This equipment is
to be used only by trained operators.
Always keep operating area clear of all
persons.
Do not allow children to operate this unit.
Seek emergency medical care if the spray
appears to have penetrated the skin! Do not
treat as a simple cut!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence
of failure exists, promptly replace all suspect
hoses and fuel lines to prevent the possibility of
injury from the high pressure spray. If a hose
or fitting is leaking, Never place your hand
directly on the leak
Never operate the gun with the trigger wired
in the open position. To prevent accidental
discharge, the trigger gun should be securely
locked when not in use.
Before removing the spray nozzle or servicing
the unit, always shut off the unit and trigger the
gun to release trapped pressure. (Even after
you shut off the unit, there is high pressure
water left in the pump, hose and gun until you
release it by triggering the gun.)
Do not direct spray on or into electrical
installations of any kind! This includes electrical
outlets, light bulbs, fuse boxes, transformers,
the unit itself, etc.
Do not allow metal components of the pressure
washer to come in contact with live electrical
components.
Operator's Manual