Télécharger Imprimer la page

AUTO-HAK Z02 Instructions De Montage page 4

Publicité

Les langues disponibles

Les langues disponibles

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
7
This towing hitch is designed to assembly in following cars:
MITSUBISHI PAJERO, V20, (V2/V4), 3/5 doors, produced since
12.1990 till 05.2000
catalogue no. Z02 and is prepared to tow trailers max
,
total weight 3300 kg and max vertical mass 135 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
1
6
5
2
3
From manufacturer
1.
Apply the main bar of the towing hitch (pos. 1) from the
10
bottom of the car to the frame of the car. Then fix it
trough the side holes of the towing hitch and existing
holes of the car frame using bolts M12x1.25x55mm (pos.
7) and M12x120mm (pos. 4) from the towing hitch
accessories – see the drawing.
2.
Fix tow ball (pos. 2) using bolt M12x75mm (pos. 5) and
M12x70mm (pos. 6). With bolt M12x75mm fix also a
socket plate (pos. 3). See figure 1.
4
3.
Tighten all bolts according to the torque shown in the
7
table.
4.
Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
5.
Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towing hitch you should get adequate note in
registration book (at authorised service station). The car should be
equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of
towing hitch must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm

Publicité

loading