Publicité
Les langues disponibles
Les langues disponibles
FMH 6150
Congratulations on purchasing your new Vivanco product. This wireless headphone
system operates using the latest transmission technology. Enjoy your favourite music or
films in top quality stereo sound without inconvenient cable connections.
A Transmitter
1
Charging indicator light
2
Operation indicator light
3
Channel selection switch
4
Audio connecting cable
5
AC adaptor connector
6
AC adaptor
7
RCA adaptor
8
Jack adaptor 3.5 mm to 6.35 mm
B RF headphone
1
Charging contacts
2
Earshell with battery compartment
3
On/off switch (OFF/ON)
4
Volume control (VOL)
5
Operation indicator light
6
Channel control
Important information
Please read these operating instructions carefully and keep them in a safe place.
Do not use the devices in water or rain.
The AC adaptors are designed for these devices only. Do not use the supplied AC
adaptors with other devices.
Avoid exposure to extreme heat or strong light.
Do not open the housings or the AC adaptors (danger of electric shock!).
Check whether the local mains voltage corresponds to the voltage indicated on the
AC adaptor.
Avoid touching the battery or charging contacts. Do not touch the contacts with
metal objects.
Do not cover the devices (e.g. with a towel, sheet, etc.)
Clean the devices using a moist cloth and never use aggressive cleaning agents.
Constant use at high volumes impairs your hearing and may cause permanent damage.
Do not dispose of this product with the domestic waste; take it to your local
electronic waste recycling depot.
Preparing your RF headphone
1.
Place the transmitter near to your hi-fi system, your TV or another audio source.
1
2
3
2.
Connect the AC adaptor to the connector on the transmitter, then plug it into a mains
CHANNEL
socket.
8
All manuals and user guides at all-guides.com
GB
3.
Connect the audio connecting cable to a headphone output, or to a line out or rec.
2
3
CHANNEL
out output. Set the volume of your audio source to 1/4 to 1/3 of the maximum volume.
4.
The operating indicator light on the transmitter lights up red when music is received.
5.
Insert the supplied batteries as described in the chapter "Using batteries or
rechargeable batteries".
6.
Switch on the RF headphone via the on/off switch.
R
7.
Turn the channel selection control on the RF headphone until the transmitter has
been located and the sound you hear becomes optimal. If the transmitter has been
R
located, the operating indicator on the RF headphone lights up green.
8.
Your device is now ready for operation.
Standby mode
The transmitter switches automatically to standby mode if it does not receive any signal
for 2 minutes or if the signal is too quiet. It switches automatically back to transmission
mode as soon as a signal is present again.
1
Using batteries or rechargeable batteries
L
Opening the battery compartment
1.
To open the battery compartment, carefully pull off the ear cushion from the left side
earshell "L". The battery compartment is located behind this.
2.
Insert the batteries or rechargeable batteries (micro, type AAA) into the battery
2
compartment, observing the correct polarity.
3.
Place the ear cushion over the battery compartment again and press it carefully until
it latches.
Charging the supplied rechargeable batteries
1.
Switch off the RF headphone.
3
2.
Place the RF headphone in the charging tray with the side marked "L" to the left.
3.
Charging of the rechargeable batteries starts automatically and the charging
L
indicator light of the charging tray switches to red.
4.
Note: Before the first use, charge the rechargeable batteries continuously
for 15 hours in order to obtain the full capacity.
The RF headphone has a protective charging function for longer battery life. After
approx. 15 hours the discharged batteries are fully charged again.
You can now enjoy music again for approx. 14 hours at an average volume.
Using different batteries
The RF headphone can also be used with other chargeable standard AAA micro batteries
or non-chargeable 1.5 V AAA batteries. Standard chargeable AAA micro batteries cannot,
however, be charged via the devices.
GB
9
Publicité
