AUTO-HAK Y23 Instructions De Montage page 4

FITTING INSTRUCTION
Original tow eye
4
6
1
A
B
3
9
16
2
This towing hitch is designed to assembly in following cars:
HONDA HR-V 3/5 door, produced since 04.1999 till 06.2001, catalogue
number Y 23 and is prepared to tow trailers max total weight 1400 kg and
max vertical load 70 kg.
The towing hitch should be install in points described by a car producer.
The instruction of the assembly
1. Disassemble the rear bumper and plastic cover below the car.
2. Untwist metal fenders from rear slice.
3. In rear slice make elongated holes according to figure 2.
4. To maked holes put jibs with nuts (pos. 4).
5. To chassis members put main bar of the towing hitch (pos. 1) and fix
by bolts M10x35mm (pos. 9) with jibs.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
4
6
9
8
A
7
6. Through holes (pos. A) and holes in rear slice twist bolts M10x35mm
(pos. 9) using big washers (pos. 6).
Cut out
Fig. 2
7. Reinstall untwisted fenders and the bumper after cut his fragment as
shown figure 3.
8. Reinstall plastic cover after cut her fragment as shown figure 4.
9. Through hole (pos. B) and original tow eye twist on bolt M10x70mm
using special scathing washers (pos. 5).
10. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm
(pos. 7) from accessories.
9
11. Tighten all bolts according to the torque shown in the table.
12. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
13. Complete paint layer damaged during installation.
M 8
M 12 85 Nm
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towing hitch
must be always kept clear and conserve with a grease.
Original tow eye hole
Cut out
Fig. 3
Fig. 4
Torque settings for nuts and bolts (8,8):
25 Nm M 10 55 Nm
M 14 135 Nm
NOTE
Cut out