Recording An Ogm (Out Going Message) - Serene VM-150 Guide D'utilisation

6. To skip the current message, press "SKIP" and it will
play the next message.
7. To stop the current message temporarily, press
"PAUSE" key; the display will show "PA". To resume
playing, press "PAUSE" again
8. To stop message playback and go back to standby
more, press and hold STOP for 2 seconds.
To Delete All Messages:
Note: This will allow you to delete all old messages only.
1. While in standby, press and hold "DELETE" for 3
seconds.
2. It will then announce "all messages deleted"
3. The digital indicator will display "00" confirming that all
messages have been deleted.

Recording an OGM (Out going message):

The VM-150 comes with 2 factory Out Going Messages
(OGM1 & 2).OGM1 is the default greeting message. OGM
1 is: "Your call cannot be answered at the moment, please
leave a message after the tone".
OGM 2 is: "Your call cannot be answered at the moment,
please call again later". If this is acceptable to you, you don't
need to record a new one.
How to choose OGM1 or OGM 2:
If you want to change from OGM 1 to OGM 2 do the following
steps:
1. While in standby, press and hold the "ON/OFF" key for
3 seconds.
2. It will announce "Out going message two" (or OGM1
depending which you have set) and start playing your
OGM 2 (1).
3. After it has been played, it will go back to standby.
4. Press "OGM" once to confirm that you have changed
your OGM to the one you want.
English