Advanced Operations; New Message Audio Alert On/Off Setting - Serene VM-150 Guide D'utilisation

Advanced Operations

Setting the Number of Rings:
1. While in standby, press the "SLOW" key once to see
the number of rings selected. (Default 4 rings)
2. Press and hold the "SLOW" key for 3 seconds and
it will announce the number of rings you have it set
to.
3. Press "VOL+" or "VOL-" to change the number of
rings or Toll Saver.
4. Press "SLOW" again to save and it will announce
"Call will be answered after "#" of rings".
Note: Toll Saver allows you to call in and check for any
new messages without incurring any long distance toll
charge. If there are new messages, the VM-150 will
answer at 3 rings; otherwise, it will answer at 6 rings.
This gives the user time to hang up quickly without
incurring any toll charges.

New Message Audio Alert On/Off Setting:

If this is enabled, every time you have a new message,
it will beep (in addition to the flashing display) every 30
seconds to alert you.
1. While in standby, press the "DELETE" Key once
until it announces "New Message Alert On"
2. Press the "DELETE" Key once and it will announce
"New Message Alert Off"
Setting Date & Time (optional):
This allows you set the current day and time so as to day/
time stamps each message. If the date and time are not
set, all your messages will not be day/time stamped. If you
have subscribed to Caller ID service, the date and time
information will get updated automatically. (Note: Year
information is not available in CID data. It must be set
manually.)
1. While in standby mode, pressing 'SET-MUTE" once
and the machine will announce the current day/time
English