Name Of Parts; Installation - Hitachi PC-ALHZF Mode D'emploi

Name of parts

3 NAME OF PARTS
Indicator Lamp
The indicator lamps are
turned ON and flash for the
conditions of "RUN", "DEF"
(defrost), "FILTER", "TIMER"
and receiving.

4 INSTALLATION

D A N G E R
• Turn OFF the power source completely before per-
forming the dip switch setting, installation work and
electrical wiring work for receiver kit. If not, it may cause
an electric shock.
• Perform securely the installation work referring to this
installation manual. If the installation is not completed, it
may cause injury by falling down the receiver kit.
• Do not install the receiver kit where the flammable gases
may generate or enter. It may cause heat generation or
a fire.
• Perform securely the electrical wiring work. If the electri-
cal work is not completed, heat generation at the connec-
tion, a fire or an electric shock may occur.
• Make sure that the electrical wires are securely fixed
in order not to apply an external force to the terminal
connections of the wirings. If fixing is not completed, it
may cause heat generation or a fire.
2 PMML0264A rev.1 - 09/2015 - P5416575
All manuals and user guides at all-guides.com
EMERGENCY
RUN
DEF
FILTER
TIMER
•
•
COOL
HEAT
N O T E
When the receiver kit is attached near electronic type lighting
which generates the ambient light, it may not receive the
signal from the wireless remote control. Pay attention to the
installation position of receiver kit.
Do not run the connecting cable for receiver kit and the power
source cable (220-240V) in parallel. It may cause malfunction
of receiver kit by noise.
Dip Switch
(Inside of receiver kit)
for function selection setting
(This switch is for installer.)
Switch for emergency
operation
Receiver