AUTO-HAK J51 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
4
7
6
This towing hitch is designed to assembly in following cars:
HYUNDAI SONATA 4 doors (NF), except V6, produced since 03.2005,
catalogue no. J51 and is prepared to tow trailers max total weight 1700 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and
correct exploitation. For this reasons we kindly ask to read carefully this
instruction and apply to hints.
The towing hitch should be install in points described by a car producer.
Assemble instruction
1. Disassemble the bumper and his reinforcement, in reinforcement cut out
fragments as shown on figure 2 and 3.
4
1
5
13
3
2
From manufacturer
2. Disassemble handles from reinforcement and make modifications according to
figure 2.
7
3. Reassemble handles to the car (without reinforcement).
4. Underneath the car to left and right chassis member fix elements pos. 4 (in
original threaded holes) using bolts M10x1,25x40mm (pos. 7), screw loosely.
6
5. To elements pos. 4 fix main bar of the towing hitch
(pos. 1) using bolts M12x40mm (pos. 6).
6. Reassemble the reinforcement and the
bumper .
left handle of the
bumper
cut
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 5)
from accessories .
8. Screw tight all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check of exploitation all bolts and nuts. The ball of towing hitch
must be always kept clear and conserve with a grease.
cut
cut – only not painted
part
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
NOTE
right handle of
cut
the bumper
reinforcement
of the bumper
bumper