Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
11
A
6
10
10
B
This towing hitch is designed to assembly in following cars:
HONDA FR-V, VAN produced since 02.2005 till 12.2010, catalogue no.
Y31 and is prepared to tow trailers max total weight 1500 kg and max
vertical load 90 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and
correct exploitation. For this reasons we kindly ask to read carefully this
instruction and apply to hints.
The towing hitch should be install in points described by a car producer.
5
6
10
E
7
1
9
18
8
3
2
From manufacturer
1.
Disassemble the bumper
-
remove two bolts in left and right wheel housing
-
remove two plastic bolts from below and two from above the bumper
C
D
11
2.
Loosen plastic covers on the left and right side of the bumper.
Remove bumper's filling (not used any more).
3.
4.
Inside the bumper unscrew two inmost bolts.
Fix element (pos. 4) through holes (pos. A) using bolts M12x35mm (pos. 10) – use
5.
washers (pos. 6) and through hole (pos. B) using bolt M8x35mm (pos. 11), see figure
1.
Fix element (pos. 5) through holes (pos. C) using bolts M12x35mm (pos. 10) – use
6.
washers (pos. 6) and through hole (pos. D) using bolt M8x35mm (pos. 11), see figure
10
1.
6
7.
Between installed elements (pos. 4 and 5) put main bar of the towing hitch (pos. 1) and
fix it using bolts M12x35mm (pos. 10).
8.
Fix main bar of the towing hitch with original tow eye through hole (pos. E) using bolt
10
M12x60mm (pos. 9), use square distance sleeves (pos. 7).
17
Reassemble the bumper after cut out his fragment – see figure 2.
9.
10. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 8) and
M12x70mm (pos. 18) from accessories .
11. Tighten all bolts according to the torque shown in the table.
12. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
13. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
The instruction of the assembly
Fig. 2
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Publicité
