AUTO-HAK G21 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
5
6
17
9
B
This towing hitch is designed to assembly in following cars:
RENAULT MEGANE I, 5 doors, produced since 1995 till 03.1999,
catalogue no. G21 and is prepared to tow trailers max total weight 1300 kg
and max vertical load 65 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
6
4
C
12
A
A
1
11
7
17
3
11
From manufacturer
1. Underside the car (in the rear panel) find plugged holes on the
10 right and left side, then make them available and put round cage
nut together with M8 nut (pos. 15).
2. Position the main bar of the towing hitch (pos. 1) underside the car
and fix it using bolts M8x30mm (pos. 12) and M10x30mm (pos.
A
11) together with large washers (pos. 17) through the holes (pos.
13
A).
3. Outside original car holes put the distance sleeves (pos. 6)
4. Position the side brackets (pos. 4 and 5) to the main bar of the
towing hitch (pos. 1) and fix it using bolts M10x30mm (pos. 11)
through the holes (pos. B).
5. Fix through the distance sleeves and towing hitch holes (pos. C)
using M10x120mm (pos. 9) and M10x90mm (pos. 10).
8
6. Tighten all nuts and bolts according to the torque shown in the
table.
7. Fix tow ball (pos. 2) using bolt M12x75mm (pos. 7) and
M12x70mm (pos. 8). With bolt M12x75mm fix also a socket plate
(pos. 3). See figure 1.
8. Connect the electric wires according to the instructions of the car.
2
9. Complete the paint cover of towing hitch (during the mounting
paint cover could be destroyed).
After install the towing hitch you should get adequate note in
registration book (at authorised service station).The car should be
equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must
be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE