AUTO-HAK G22 Instructions De Montage

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
A
11
10
12
13
5
8
10
B
This towbar is designed to assembly in following car:
RENAULT MEGANE CLASSIC produced since 1996 till 1998 and
since 1999 till 2002, catalogue no. G22 and is prepared to tow trailers max
total weight 1300 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed
in many tests. Reliability of towbar depends also on correct assembly and
right operation. For this reasons we kindly ask to read carefully this
instruction and apply to hints.
The towbar should be install in points described by a car producer.
13
12
9
4
C
A
B
11
10
13
22
1
23
A
7
24
6
2
3
The instruction of the assembly
1. Below a car, in rear side, find plugged holes (left and right side) – upper A
holes of towbar. Next remove plugs and put „nut with basket M8" pos. 23
- only for model Renault Megane Classic I produced since 1996 till 1998,
or „Caged Nut M8" pos. 22 - only for model Renault Megane Classic II
produced since 1999 till 2002.
2. Main bar of towbar (pos. 1) put below the car and through holes (pos. A)
fix using bolts M8x30mm (pos. 11) and M10x30mm (pos. 10), use big
washers (pos. 13) too.
3. From outside, in original holes in chassis members put distance sleeves
10
(pos. 12) from accessories.
4. To already installed main bar (pos. 1) through holes (pos. B) fix side
brackets (pos. 4 and 5) using bolts M10x30mm (pos. 10)
22
5. Through previously installed distance sleeves in chassis members and
towbar holes (pos. C) fix all using bolts M10x120mm (pos. 8) and
M10x90mm (pos. 9) from accessories.
23
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm (pos.
6) and M12x70mm (pos. 7) from accessories.
7. Fix tight all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the instruction of the
car. (Recommend to make at authorized service station)
9. Complete the paint coating damaged during installation.
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate registration in registration book
(at authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
M8 - 25 Nm M10 - 50 Nm
M14 - 138 Nm M16 - 210 Nm
NOTE