AUTO-HAK T51A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
6
8
9
A
8
7
B
This towing hitch is designed to assembly in following cars:
KIA SORENTO 5 doors (JC), produced since 08.2006 till 10.2009,
catalogue no. T51A and is prepared to tow trailers max total weight 3500
kg and max vertical load 140 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
6
4
8
1
10
3
From manufacturer
1. Take out the spare wheel.
2. Disassemble the bumper.
8
3. Disassemble transverse reinforcement (will not be assembled again).
4. Apply right bracket (pos. 4) and left (pos. 5) to frame of the car in that way so
holes A be covered with threaded holes in the frame and fix loosely using
9
bolts M12x1.5x40mm (pos. 8).
5. Fix side brackets (pos. 6) to frame of the car using bolts M12x4.5x40mm (pos.
8) and then fix them to right bracket (pos. 4) and left bracket (pos. 5) using
B
bolts M12x35mm (pos. 9), see drawing 1.
10
6. On protruding pins in rear slice apply the main bar of the towing hitch (pos. 1)
and fix using bolts M10x50mm (pos. 10) and M12x50mm (pos. 7) together
with brackets (pos. 4 and 5).
7. Through holes B of the towing hitch drill holes ø12.5mm and fix using bolts
M12x50mm (pos. 7), see drawing 1.
7
8. Tighten all bolts according to the torque shown in the table.
9. Install the bumper after cut out of its fragment, see drawing 2.
2
10. Fix body of the automat and place tow-ball according to supplied instruction.
Note! Remember to place socket plate (pos. 3) as shown on the drawing 1.
11. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station).
12. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration book (at
authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towing hitch
must be always kept clear and conserve with a grease.
The instruction of the assembly
60
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Fig. 2