AUTO-HAK T44A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
11
10
5
10
4
7
6
8
This towing hitch is designed to assembly in following car:
KIA SEPHIA 4/5 door (FA), produced since 01.1995 till 05.1998,
catalogue no. T44A and is prepared to tow trailers max total weight 1450
kg and max vertical load 50 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
exploit. For this reasons we kindly ask to read carefully this instruction and apply
to hints.
The towing hitch should be install in points described by a car producer.
11
10
5
4
7
6
1
3
The instruction of the assembly
1. Disassemble the rear bumper.
2. From left and right bumpers fastening twist off original screws and
put screws M10x45mm (pos. 7).
10
3. On rear panel are 8 original holes (4 per each side) ø8mm, drill it
using bit ø10mm.
4. Put main bar of towing hitch (pos. 1) on screws (pos. 8)protruding
from the bumper. All unit (main bar and bumper) put to rear panel
and fix by nuts (loosely), remember abort big washers (pos. 10)
and distance sleeve (pos. 6) on the left side. Do not twist on nuts in
places where will be brackets pos. 4, see drawing.
5. From below the car put suitable brackets (pos. 4) to chassis
members. Through brackets hole drill holes ø10,5mm to the trunk.
From trunk side drill it again using bit ø15mm (only in upper side
of chassis members). From trunk side to drilled holes put distance
sleeves (pos. 5) and fix it according to the drawing. Fix brackets to
main bar of the towing hitch, remember about sleeve (pos. 6) on
the right side.
6. Fix body of the automat and place tow-ball according to supplied
instruction. Note! Remember to place socket plate (pos. 3) as
shown on the drawing 1.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-pole socket according to the instruction
of the car. (Recommend to make at authorized service station)
9. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
Torque settings for nuts and bolts (8,8):
M8 25 Nm M10 55 Nm
M12 85 Nm M14 135 Nm
NOTE