Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
6
4
This towbar is designed to assembly in following car:
RENAULT MEGANE II, 4 doors, produced since 09.2003, catalogue no.
G43 and is prepared to tow trailers max total weight 1300 kg and max
vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
4
6
1
14
13
15
12
13
3
From manufacturer
1. Disassemble a bumper and metal reinforcement (not used any
more).
2. Slip main bar of the towbar (pos. 1) to chassis members and
next screw it using bolts M10x40mm (pos. 6) from
accessories (use flat washers – pos. 4).
3. Assemble a bumper.
4. Fix tow-ball (pos. 2) and using bolts M12x75mm (pos. 5)
from accessories.
5. Fix the socket plate (pos. 3) as shown on the drawing.
6. Tighten all bolts according to the torque shown in the table.
5
16
7. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station)
8. Complete the paint coating damaged during instalment.
2
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
Fitting instructions
Torque settings for nuts and bolts (8,8):
M 8
25 Nm
M 10 55 Nm
M 12 85 Nm
M 14 135 Nm
NOTE
Publicité
