AUTO-HAK W28A Instructions De Montage page 5

Towing hitch accessories:
Fig. 3
Fig. 4
Cut out
Cut out
rear panel
Cut out
Towing hitch (without electrical set)
W28A
Cat. no.
Class: A50-X
Designed for:
Manufacturer: SUZUKI
Model: SPLASH, 5 doors
produced since 04.2008
Manufacturer: OPEL
Model: AGILA, 5 doors
both produced since 03.2008
Approval number according to Directive 94/20/EC: e20*94/20*0734*00
Before start of installation always refer to vehicle's
technical manual prior to install and use towbar to make sure
that the particular Opel Agila / Suzuki Splash you are working
on is prepared for this. Not all models Opel Agila / Suzuki
Splash are prepared for towbar use!
This towing hitch is designed according to rules of safety traffic regulations. The
towing hitch is a safety component and can be install only by qualified personnel.
Any alteration or conversion of the towing hitch is prohibited and would lead to
cancellation of design certification. Remove insulating compound and underseal
from vehicle (if present) in the area of the matting surfaces of the towing hitch.
The vehicle manufacturer's specifications regarding trailer mass and max. vertical
cup mass are decisive for driving whereat values for the towing hitch cannot be
exceeded.
D-value formula:
Max trailer weight [kg] x Max vehicle weight [kg]
+ Max vehicle weight [kg]
Max trailer weight [kg]
PPUH AUTO-HAK S.J.
Produkcja Zaczepów Kulowych
Henryk & Zbigniew Nejman
76-200 SŁUPSK ul. Słoneczna 16K
tel/fax (059) 8-414-414; 8-414-413
E-mail: office@autohak.com.pl
www.autohak.com.pl
Technical data:
D-value: 4,5 kN
maximum trailer weight: 600 kg
maximum vertical cup mass: 50 kg
NOTE!
Foreword
9,81
= D [kN]
X
1000