The Suction Motor Does Not Function; Excessive Foam Production - COMAC OMNIA 26 Mode D'emploi

THE SUCTION MOTOR DOES NOT FUNCTION

THE SUCTION MOTOR DOES NOT FUNCTION THE SUCTION MOTOR DOES NOT FUNCTION THE SUCTION MOTOR DOES NOT FUNCTION
1. Check that the signal lamp of the suction motor switch is on
2. Check whether the recovery tank is full; eventually empty it
3. In the automatic versions, the suction motor works only when the squeegee is
lowered. Check that the selector is on the "AUTO" position and move forward of
some metres.
4. Check the perfect float condition of the recovery tank filter (see under "CLEANING OF
THE RECOVERY TANK FILTER")

EXCESSIVE FOAM PRODUCTION

EXCESSIVE FOAM PRODUCTION
EXCESSIVE FOAM PRODUCTION EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If required, add a small quantity of
antifoam liquid into the recovery tank.
Remember that, when the floor is not very dirty, more foam is generated. In this case
dilute more the detergent.
TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE
48