Squeegee Automatic-Manual; Brushes Pressure Manual; Brushes Pressure With Automatic Control - COMAC OMNIA 26 Mode D'emploi

Masquer les pouces Voir aussi pour OMNIA 26:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ATTENTION!
ATTENTION!
ATTENTION! Whenever problems during operating occur, lower
ATTENTION!
promptly the lever of the emergency brake placed on the rear right
side of the machine. This command will block immediately the traction
of the machine.
To restart the machine again, press the releasing trigger and lift the
lever of the emergency brake; then push forward the lever on the
handle bar.

SQUEEGEE AUTOMATIC-MANUAL

SQUEEGEE AUTOMATIC-MANUAL
SQUEEGEE AUTOMATIC-MANUAL
SQUEEGEE AUTOMATIC-MANUAL
The machines with automatic version have the possibility to control electrically the
squeegee movement. Depending on the position of the switch (1) the following
functioning systems are activated.
Automatic If the switch is placed on automatic, lowering of the squeegee and starting
Automatic
Automatic
Automatic
of the suction motor are obtained with the machine advancement. Also,
lifting of the squeegee and stopping of the suction motor are achieved with
the reverse motion of the machine.
Manual
Manual
Manual
Manual
If the switch is placed on manual, the squeegee lifts and lowers itself
manually through the commutator (2). The operation of the suction motor
is commanded anyhow through the squeegee.

BRUSHES PRESSURE MANUAL

BRUSHES PRESSURE MANUAL
BRUSHES PRESSURE MANUAL
BRUSHES PRESSURE MANUAL
Brushes pressure can be adjusted through the lever shown in the figure. There are three
predetermined positions. Major is the pressure when the lever is in the highest position.
The pressure must be chosen based upon the type of floor and the type of dirt.
Excessive pressure causes higher brushes wear and major energy consumption.

BRUSHES PRESSURE WITH AUTOMATIC CONTROL

BRUSHES PRESSURE WITH AUTOMATIC CONTROL
BRUSHES PRESSURE WITH AUTOMATIC CONTROL
BRUSHES PRESSURE WITH AUTOMATIC CONTROL
In case of machines equipped with automatic control (machines with actuator), the lever
for the adjustment of the brushes pressure allows four different levels. Also in this case,
major is the pressure onto the brushes when the lever is in its highest position.
PERFORMANCE
PERFORMANCE
PERFORMANCE
PERFORMANCE
40
AUTO MAN
1
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Omnia 32Omnia 42

Table des Matières