Disassembling And Maintenance - acerpure pro Serie Manuel De L'utilisateur

Disassembling and Maintenance

Filter Replacement
The appliance must be disconnected from the supply main.
1
1. After switching off the power and unplug-
ging the power plug, pull the handle on the
filter cover behind the product backward.
* The recommended replacement time for the filter is after 3000 hours of use.
* When the filter replacement indicator lights up, please remove the filter and replace or clean the filter based on the filter's cleanliness.
* After installing the filter back into this product, press and hold down the power button and purifier wind speed button simultaneously for 3 seconds to
turn off the filter replacement indicator.
* Please avoid pulling the power cord during disassembly to prevent the power cord from breaking.
* When using this product for the first time or replacing a new filter, please remove the packaging bag of the filter first and then start using this product.
Maintenance
This product only requires general external cleaning
and maintenance (as shown in the figure).
Do not wipe with thinner, toluene, acidic cleansers,
lamp oil, alcohol, or chemical cloth in order to avoid
discoloration or deterioration.
Please note: After maintenance and cleaning, wait for
the product to fully dry before connecting power to
use again or storing. If the product needs to be stored,
please place the product back into the packaging box
in the original packaging order, and place it at a dry
location for safekeeping.
2
2. Remove the filter and replace it
with a new filter.
Use a vacuum cleaner to remove
the dust from the air outlet and inlet.
12
3
3. Place the filter cover back
onto the product.
Use a soft cloth to wipe the
exterior and the sensor cover at
the back of the product.