Sicce Syncra ADV 5.5 Manuel D'instructions page 16

EN
Dear valued Customer, thank you for choosing SYNCRA ADVANCED. This new generation of Syncra
Silent pumps are highly efficient products that have been developed and manufactured in Italy to meet
the most stringent quality and performance requirements. SYNCRA ADVANCED are ideal to be used in
marine and fresh water aquariums, decorative fountains, protein skimmers, and water-cooling systems.
SYNCRA ADVANCED can be used fully submersed or for inline (external) applications. The pumps have
a turning pre-chamber, which makes them easy to use for many applications in tight spaces. The unique
closing ring allows the pumps to be maintained easily and without screws or tools. Please, read carefully
and save the following instructions for best practices and use of the SYNCRA ADVANCED pump.
SAFETY INSTRUCTIONS:
SYNCRA ADVANCED is made in conformity with the national and international security laws.
1) Always isolate the pump from the main electricity before installing or carrying out any maintenance.
2) The pump can work submerged or inline out of water.
3) Before connecting the pump to the electricity supply, check there are any damages on cord or plug.
4) The pump has a type Z cable link. The cable and the plug cannot be substituted or repaired; in case
of damage replace the entire pump.
5) ATTENTION: do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning,
or if it has been dropped or damaged in any way.
6) The pump must not work without water to avoid damages to the motor.
7) The pump can be used in liquids or in environment with a temperature not higher than 35° C / 95° F.
8) Do not use the pump for uses different to those for which it has been projected as, i.e. in bathroom
or similar applications.
9) Avoid using the pump with corrosive and abrasive liquids.
10) The pump cannot be used by people with handicaps or by children if they are not supervised by a
person responsible for their safety.
11) To avoid that accidental drips wet the plug or the socket, make a loop with the cord under the
socket level (Pic. A).
12) Avoid to take the pump by the cord during the installation or maintenance.
13) The pump can be used only in the above mentioned applications and it is only for internal use (3
meters long cable).
14) If the pump or the filter is supplied with a cable 10 meters long, or more than 6 feet long for the
American type (USA), these appliances are intended for outdoor use as required by international
standards.
COMPONENTS
SYNCRA ADVANCED pumps are designed favoring the almost total dismantling of their components,
to facilitate proper use and maintenance and ensure a long life. Below is the list of the individual parts
and spare parts (Pic. B):
1. Motor body completely submersible and insulated by epoxy resin;