Sicce Syncra ADV 5.5 Manuel D'instructions page 12

IMPORTANT SAFETY INSTRUCTIONS
WARNING To guard against injury, basic safety precautions should be observed, including the following.
READ AND FOLLOW
ALL SAFETY INSTRUCTIONS
CAUTION Always disconnect the pump when not in use, before adding or removing parts and before
cleaning.
- Do not allow pump to run dry. Pump must be immersed in water completely.
- This pump is to be used in a circuit protected by a ground fault circuit interrupter.
WARNING
To reduce the risk of electric shock, install only on a circuit
protected by a Ground - Fault Circuit - Interrupter (GFCI).
To reduce the risk of electric shock, use only in portable self-
contained fountain no larger than 5 feet in any dimension.
This pump has not been designed for use in swimming pool
or marine areas.
To avoid possible electric shock, special care should be taken
since water is employed in the use of aquarium or pond
equipment. For each of the following situations, do not attempt
repairs by yourself. Return the appliance to an authorized
service facility for service or discard the appliance.
1) Do not operate any appliance if it has a damaged cord or
plug, or if it doesn't work properly or has been dropped or
damaged in any manner.
2) To avoid the possibility of the appliance plug or receptacle
getting wet, position aquarium stand and tank or the fountain
to one side of a wall-mounted receptacle to prevent water
from dripping onto the receptacle or plug.
A "drip-loop" (PIC. A) should be arranged by the user for
each cord connecting an aquarium appliance to a receptacle.
The "drip-loop" is the part of the cord below the level of the
receptacle or the connector if an extension cord is used, which
prevents water from travelling along the cord and coming in
contact with the receptacle.
If the plug or socket does get wet, DON'T unplug the cord.
Disconnect the fuse or circuit breaker that supplies power to