Axis Q35-VE Serie Guide D'installation page 26

AXIS Q35-VE Series
Reset to Factory Default Settings
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available from the support pages
on www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware Overview on
page 10.
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup >
System Options > Maintenance and click Default.
Further information
• For the latest version of this document, see www.axis.com
• The user manual is available at www.axis.com
• To check if there is updated firmware available for your product, see
www.axis.com/support
• For useful online trainings and webinars, see www.axis.com/academy
Warranty Information
For information about Axis' product warranty and thereto related information, see
www.axis.com/warranty/
26