Télécharger Imprimer la page

Troubleshooting; Self Diagnosis Display; Dépannage; L'écran Self Diagnosis - Samsung SC-X300 Mode D'emploi

Caméscope sports

Publicité

ENGLISH

Troubleshooting

Self Diagnosis Display

Display
Informs that...
Not enough free
Not enough free space
space.
for saving files.
Corrupted file.
The file is corrupted.
Paper error!
Paper has run out.
Ink error!
Ink is low.
Communication
An error has occurred
Error!
while transferring data.
Low battery
Battery is low.
Holding the key
The HOLD switch is
locked.
Card error
The memory card is
corrupted.
Not formatted
Format the memory
card.
Write error
Failed to write.
Read error
Failed to read.
Not supported
The format is not
format
supported.
Write protected
Memory card is
protected to write.
MPEG decoding
The movie file is
Error
corrupted.
✤ If these instructions do not solve your problem, contact your nearest
Samsung dealer or authorized service center/personnel.
Symptom
Possible Causes
No power is
The power is not connected
supplied
properly
The battery is dead
The battery is too cold
Date/Time is wrong The Date/Time is not set
Action
Check the space of the memory
card.
Delete the corrupted file.
Check the paper in the printer. If
there is no paper, insert the paper.
Check if the ink or toner is low.
Disconnect the USB cable and
connect it again.
Charge the battery pack or connect
the AC Power Adapter.
Unlock the HOLD switch and
operate the Sports Camcorder.
Format the memory card or replace
it with a new one.
Format the memory card.
Check the memory space or format
the memory.
Delete the file.
The file format is not supported.
Check the supported file. on page
29.
Unlock the memory card. (except
MMC)
Delete the corrupted file.
Measure
Connect the AC Power
Adapter properly, page 24
Replace the dead battery pack
Warm up the battery or move
to warmer place
Set the Date/Time, page 78
Dépannage
L'écran Self Diagnosis
Donne les informations
Affichage
suivantes...
Not enough free
Pas assez d'espace libre
space
pour enregistrer les fichiers
Corrupted file
Ce fichier est altéré
Paper error!
Il n'y a plus de papier.
Ink error!
Le niveau d'encre est bas. Vérifiez le niveau d'encre.
Communication Error! Une erreur est survenue
lors du transfert des
données.
Low battery
Le niveau du bloc-piles est
bas.
Holding the key
L'interrupteur HOLD est
verrouillé.
Card error
La carte mémoire est
altérée.
Not formatted
Formatez la carte mémoire. Formatez la carte mémoire.
Write error
Impossible d'écrire.
Read error
Impossible de lire.
Not supported format Le format n'est pas
accueilli.
Write protected
La carte mémoire est
protégée en écriture.
MPEG decoding Error Le fichier vidéo est altéré
✤ Si ces instructions n'apportent aucune solution à votre problème, contactez votre
revendeur le plus proche, un technicien ou un centre de services techniques agréés
Samsung.
Problème
Causes possibles
Il n'y a pas d'
Le câble d'alimentation
alimentation
n'est pas branché
correctement
Le bloc-piles est à plat
Le bloc-piles est trop froid
Date / heure
La date et l'heure ne sont
erronnées
pas réglées
FRANÇAIS
Action
Vérifiez l'espace restant sur la carte
mémoire.
Supprimez le fichier altéré.
Vérifiez la quantité de papier dans l'
imprimante. S'il n'y en pas, insérez
du papier.
Débranchez le câble USB et
rebranchez-le.
Rechargez le bloc piles ou branchez
l'adaptateur CA.
Déverrouillez l'interrupteur HOLD et
faites fonctionner le caméscope.
Formatez la carte mémoire ou
remplacez-la.
Vérifiez l'espace mémoire ou
formatez la carte mémoire.
Supprimez le fichier.
Le format de fichier n'est pas
accueilli. Vérifiez le format de fichier
qui peuvent être accueillis à la page
29.
Déverrouillez la carte mémoire.
(Sauf MMC)
Supprimez le fichier altéré.
Solution
Connectez l'adaptateur CA
correctement, voir page 24
Remplacez le bloc piles à plat
Réchauffez le bloc-piles ou déplacez-
le dans un endroit plus chaud
Réglez la fonction Date/Time, page
78
107
107

Publicité

loading

Ce manuel est également adapté pour:

Sc-x300l