Publicité
Les langues disponibles
Les langues disponibles
Operating:
• switch on the sensor with pushbutton (A) the operating indicator (B) will
light green after a few seconds. After 4 min heating phase indicated by
the green indicator the sensor will be ready to detect gases.
Indicator will flash green.
• If the Gas alarm detects gas it will send a Signal to the main unit which
turns into alarm mode immediately. If the gas alarm still detects gas
after 30 seconds, it will trigger an alarm again. Fast flashing operating
indicator indicates an alarm.
• If the operating indicator is permanently green during normal operation
(after heating phase) a sensor fault is indicated.
Technical specifications:
Power supply:
Current consumption:
Weight:
Detection:
Range:
Tx frequency:
Tx Power:
Delivery scope:
Radio Gas Alarm, power cable, manual, mounting materials,alarm sticker
The user has to make sure that the devices are mounted
and used in a manner which ensures the prevention
of material damages, injuries, or accidents. In case of
disregarding the obove desribed mounting instructions, the
user takes full responsibility. The manual is translated from
English
12/24VDC
appx. 70mA
appx. 60g
from 50ppm narcotic gas, Propane, Butane
appx. 50mtr (cleared area)
868,35MHz
<10mW
Important remark:
german.
Publicité
