aldes Modbus EasyVEC Notice page 2

Modbus EasyVEC
remote control manual
1. BUTTONS
: Back
: Increase a value and navigate
: Decrease a value and navigate
: Validate
Ambient temperature (storage): -25 ° C to + 65 ° C / Relative humidity from 30% to 100%
2. INSTALLATION AND CONNECTION
The Modbus harness is mounted on the Pin & Past J3 connector at the rear of the box following the marking
on the card:
- Mass
- Terminal A
- Terminal B
3. WATER PROTECTION
IPX0 DO NOT use outside.
The installation must be done in place protected from water.
4. NAVIGATION
EasyVEC Ultimate
Soft version 0.23
ID # 110349991
LANGUAGES
French
English
®
- Voltage + V
- Cable section: 4 x 0.35 mm²
or 4 x 0.5 mm²
CONFIGURATION CONFIGURATION
Controls
... Reset
SETTINGS
Color
... Language
ERROR LOG ERROR LOG
E31: C4 detection
during 3 s.
Installation instructions
- Remove the front part with a tool (e.g: screwdriver)
- Mount to the wall using a an in-wall flush box (67 mm diameter)
- Run the Modbus cable through the cable outlet hole (4 wires between
0.22 and 0.5 mm²)
- Connect the wires to the connector
- Mont the front face back on
CONFIGURATION
Reset
... Controls
SETTINGS SETTINGS
Language
... Serial number
ERROR LOG
E55: motor RPM
during 3 s.
2
EN
CONFIGURATION
Controls
... Reset
www.aldes.com