Expedition Pro Xp100 - Samson Audio Expedition Pro XP100 Mode D'emploi

Guided Tour
1: 1/4" input - Use this standard 1/4" connector to connect signal from a power
amplifier (rated at up to 250 watts into 8 ohms) to the XP100.
2: Speakon™ input - Alternatively, you can use this Speakon™ connector to connect
signal from a power amplifier (rated at up to 250 watts into 8 ohms) to the XP100.
3: 1/4" extension - Use this standard 1/4" connector to daisy-chain one XP100 to
another. See below for interconnection diagrams.
4: Speakon™ extension - Alternatively, you can use this Speakon™ connector to
daisy-chain one XP100 to another. See below for interconnection diagrams.
Speakon™ Wiring
+
-
Interconnecting the XP100
Using one XP100: A single mono signal (bus or aux send) is
routed from a mixer to a power amplifier.
output of the power amplifier is connected to either the
XP100 1/4" input connector (solid line) or Speakon™ input
connector (dotted line).
5
5

Expedition Pro XP100

One speaker