Aurora AU1520XA Mode D'emploi page 3

OPERATION :
Face plate in position
for shredding paper.
Features a CD/DVD destroyer:
Do not hold CD/DVD with finger through the center ring while feeding into the shredder.
Serious injury may occur. Never feed more than one credit card or CD/DVD at a time.
1) Hold the CD/DVD by the edge and feed one at a time, releasing when shredding begins.
2) Shredder will stop when the entire disc has been destroyed.
LED Status indicators:
Overheat Paper Overload
(red light) (red light)
! WARNING :
Avoid touching the document
feed opening with hands.
Product is not intended for use by
children (product is not a toy).
Do not insert foreign objects into
the document feed opening.
3
Continued on next page
Cover completely shuts
feed entry slot. Open to shred.
Face plate in position for
shredding CDs/DVDs and
credit cards.
Door Open Basket Full Power On
(red light) (red light) (green light)
Do not spray or keep any aerosol
products in or around shredder.
Avoid loose clothing or jewelry
touching the document feed opening.
Avoid getting hair near the
document feed opening.
! WARNING :
- RISK OF FIRE. Never use any petroleum based or flammable oils or lubricants in or around the
machine as some oils can combust causing serious injury.
- NEVER dispose of flammable chemicals or materials that have come into contact
with flammable chemicals (for example, nail polish, acetone, gasoline) in the shredder basket.
- Never shred plastic (except credit cards and CD/DVDs), any hard materials, continuous
forms, newsprint, or anything with adhesives including labels and envelopes.
- Do not hold CD/DVD with finger through the center ring while feeding into the
shredder. Serious injury may occur.
- A socket-outlet should be near the equipment and be easily accessible.
- Always turn the shredder off and unplug the power cord from the AC outlet before cleaning it,
moving it, or emptying the waste basket.
- Never let the wastebasket become full. This will lead to shredded material being pulled back up into
the shredder and cause jams.
- Never place the shredder near water or any heat source.
- Keep wastebasket emptied so that the shredder output is not impeded.
- Do not use the shredder if the power cord is damaged in any way.
- Do not attempt to service this product yourself as doing so may expose you to sharp cutting blades
and/or electricity and will void the manufacturers warranty.
- Never try to clean or clear the shredder blade.
TROUBLESHOOTING FOR AURORA PAPER SHREDDERS :
The shredder does not work at all.
a) Make sure the unit is plugged in and that the outlet it is plugged into is in good working order.
b) Shredders with pull-out wastebaskets features a safety power cut off upon bin removal.
Make sure the pull-out wastebasket is properly set back into place.
c) In the event that the shredder is run continuously for too long and the motor overheats, a thermal
overload switch will automatically shut the power off. If this happens, move the switch to the off
position for 30 minutes or more before continuing.
The shredder runs in "Rev" mode but not in "Auto" mode.
a) While in "Auto" mode, the motor will not start running until paper is inserted into the
feed slot. Set the unit to "Auto" and insert paper to be shredded. It is normal for the motor to run for
a moment after setting it to "Auto" but it should stop until paper is inserted. The trigger that activates
the shredder in Auto mode is located directly in the center of the slot. If the paper you are inserting is
narrow, it may not be hitting the switch. It is possible that the trigger, which activates the shredder,
has become blocked with paper. Insert an index card, directly in the center of the feed slot, and apply
force. This will usually clear any paper blocking the switch and force the switch closed.
4