Publicité
Les langues disponibles
Les langues disponibles
Crosscut Paper Shredder
Operating Instructions
Installation
Operation
Warning
Troubleshooting
Maintenance
Limited Warranty
Déchiqueteuse à coupe croisée
Manuel de fonctionnement
Installation
Fonctionnement
Avertissement
Dépannage des déchiquteuses
Entretien
Garantie limitée
Máquina destructora de
documentos de corte transversal
Instrucciones para operar
Instalaciones
Operación
Avertencia
Solucionar Problemas de la
Máquina Trituradora
Mantenimiento
Garantía Limitada
*
ONE FOLDED SHEET OF PAPER EQUATES TO 2 SHEETS OF PAPER
Heavier paper, humidity or other than rate voltage may reduce capacity.
*
UNE FEUILLE DE PAPIER PLIÉE ÉQUIVAUT À DEUX FEUILLES
Le papier plus épais, l'humidité et une tension différente de la tension nominale peuvent réduire la capacité.
*
UNA HOJA DE PAPEL DOBLADA EQUIVALE A 2 HOJAS DE PAPEL
Si el papel es más pesado, si está húmedo a las tensión es otra, la capacidad puede disminuir.
1
15 sheets of
Sheet Capacity
20lb. bond paper
3/16" x 1 3/8" pieces
Paper Shred Size
0.46 cm x 3.5 cm pieces
Paper Entry Width
9.1" / 23.0 cm
Credit Card & CD Capacity
1 at a time
Voltage
120V~60Hz 4.5 A
Capacité de passage
15 feuilles de papier
à la fois
bond de 75g/m2 (20lb.)
en morceaux de 3/16" x 1 3/8"
Dimensions des déchets
en morceaux de 0.46 cm x 3.5 cm
Largeur d'entrée
23,0 cm (9,1 po)
Capacité de CD et
les introduire un par un
les cartes de crédit
Tension
120V~60Hz 4.5 A
Capacidad de
15 hojas de papel
destruccióna la vez
de cartes de 20 libras
en pedazos de 3/16" x 1 3/8"
Tomaño de corte
en pedazos de 0.46 cm x 3.5 cm
Apertura de la alimentación
9.1" / 23.0 cm
Capacidad de CDs y
introdúzcalos en la ranura
tarjetas de crédito
uno por uno
Voltaje
120V~60Hz 4.5 A
INSTALLATION :
Carefully unpack the shredder and connect the power cord to any standard 120 volt AC outlet.
*
Make sure the basket door is securely closed shut. Shredders with pull-out wastebaskets features a
safety power cut off upon bin removal. (FIGURE 1)
Caution: Crosscut shredders have very sharp, exposed blades on the underside.
*
FIGURE 1
OPERATION :
Using the power button or switch, turn on the shredder (FIGURE 2). The green light will indicate if the
shredder is powered on.
I
Auto: This setting allows the shredder to be automatically started by inserting paper into the
shred opening. Always feed the paper in as straight as possible. When the paper has
passed through, the shredder will automatically stop. (FIGURE 2)
O
*
Off: This setting turns off all features of the shredder. For safety reasons, we recommend that
you leave the shredder in the "Off" position whenever the shredder is unattended or
not in use. (FIGURE 2)
REV: In the unlikely event of a paper jam, the reverse setting can be used to help clear the
cutters of paper that has not passed through. Never attempt to clear a jam by using
the reverse function until you have emptied the wastebasket. (FIGURE 3)
FW: The forward setting can also be used to help clear the cutters in the event of a paper jam.
This allows to manually activate the shredder into cutting mode. (FIGURE 3)
Never shred plastic (except credit cards and CD/DVDs), any hard materials, continuous
forms, newsprint, or anything with adhesives including labels and envelopes.
While this shredder will shred staples, it is recommended that you remove them whenever possible in
order to extend the life of your shredder.
Only shred credit cards by feeding them vertically within the designated area.
Never feed more than one credit card at a time.
FIGURE 2
FIGURE 3
2
Publicité
