Setting Up - Delta MAYOR D 1 Gr Mode D'emploi

5. SETTING UP

5.1 WARNINGS
The manufacturer has reasonably predicted all possible hazards and user safety but
different installation and transport conditions may cause uncontrolled and unpredictable situations,
for this reason it is mandatory to evaluate eventual residual risks and taking under account the
indications below:
Setting up and tuning operations on the machine must be executed by qualified and authorized
personnel.
A. Confirm the integrity of components and in case of malfunction and/or defect, suspend
installation and replace machine.
B. Always visually inspect the machine box: abnormalities and/or defects must be reported to
the forwarder
C. Open the top of the box and lift the machine holding it by its base. This procedure should be
carried on by at least 2 persons.
D. Packaging elements (metal clips, cellophane, etc.) may cause hazards like cuts, if they're not
handled with care. Keep out of children's reach.
E. Remove all accessories: manuals, filter holders, cleaning material, etc.
F. Position the machine in a perfectly horizontal plane. Adjust the feet to achieve so; Use a
counter with enough resistance and rigidity to hold the load and assure the stability of the machine.
Make sure there is enough space between the machine and the walls to allow correct ventilation.
G. Do not obstruct ventilation holes.
H. Make sure the sewage pipe has a siphon.
1. Power line
2. Residual-current device (RCD)
3. Power cord
4. Machine main switch
5. Purified water entrance
6. Discharge box
7. Discharge tube
8. Sewage pipe
9. Passage valve
10. Water network entrance
11. Water network to purifier tube
12. Water purifier
13. Purifier to machine water entrance tube
47
Picture 5.1