Fein ALG30 Mode D'emploi page 9

ALG 30_40.book Seite 9 Montag, 4. August 2008 11:29 11
Meaning of the LED indications.
LED indication
continuous yellow light
green flashing light
continuous green light
red flashing light
green flashing light and red
flashing light
Repair and customer service.
Once per week; more often in case of frequent usage:
Keep the contacts in the slide-on shoe clean.
– Clean electrical contacts only dry.
– Pay attention that metal chips do not enter the housing
of the battery charger.
When replacing the power tool's cable is required, have
this carried out by FEIN or by an authorized FEIN Service
Agent, in order to avoid hazardous situations.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your battery charger may include
only a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the documents and standards given on
the last page of this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out battery chargers and accessories
should be sorted for environment-friendly recycling.
Meaning
The battery charger is ready for operation; mains voltage is given.
The rapid charging is active.
The rapid charging is ended and the trickle charging is active.
Charging not possible due to the following possible reasons:
1. Contacts contaminated. Improvement measure: Clean the contacts by
inserting and removing the battery several times.
2. The battery is defective. Improvement measure: Replace the battery!
The battery temperature is not within the charge-temperature range of 0 °C
to +45 °C. The rapid charging procedure starts as soon as the battery
reaches the allowable charge-temperature range.
en
9